Running windows xp when I try to choose Win95/98/nt I get an error PPGetPort_Error#53 file not found.Also I only have 384 ram is that why motors wont run they just seem to get hot.And finally on the table setup the ramp rate is in Hz/step instead of IPM/in what do I set that to.There is also a CV Angle box whatever that is.Was having a lot of fun doing the mechanical end of this build but a total newbie to electronics and setup.
This is closer to the problem you have described before.
KCam seems not to see the Parallel Port.
Please make sure it is enables in Bios.
Also it should be EPP or ECP Mode.
Check in Hardwaremanager that XP knows the Parallel Port and note down the base address.
from there you have much better chances ;-)